| |
| |
|
|
| |
HOW TO HANG WALLPAPER
YOU NEED THE FOLLOWING TOOLS END EQUIPMENT:
* A SMOOTH GROUND / TABLE ON WHICH YOU COULD SPREAD WALLPAPER OUT.
* A FOLDING LADDER.
* A TAPE MEASURE.
* A BUCKET FOR ADHESIVE PREPARATION AND A WOODEN STICK TO MIX IT.
* A WATER GAUGE, A PLUMB LINE, AND A PENCIL TO CHECK ALIGNMENT.
* A SCISSORS AND A PUTTY KNIFE TO CUT WALLPAPER.
* A BRUSH TO APPLY ADHESIVE.
* A ROLL AND CLEAN CLOTH TO FLATTEN.
|
 |
 |
 |
PREPARATION OF THE WALL
THE WALL SURFACE MUST BE DRY, CLEAN AND SMOOTH. CRACKS AND HOLES, IF ANY, ON
THE WALL MUST BE FILLED AND LEVELED WITH PLASTER. FOR PREVIOUSLY PAINTED
WALLS, ANY SWELLINGS MUST BE SCRAPED AND SAND.
FOR SYNTHETIC PAINTED WALLS, THE SURFACE MUST BE SAND UNTIL IT BECOMES MATT.
IF ANY WALLPAPER HAS BEEN PREVIOUSLY APPLIED ON THE SURFACE, SUCH OLD WALLPAPERS MUST BE SOFTENED WITH A BRUSH BY APPLYING WARM WATER OR WELL-DILUTED WALLPAPER GLUE, THEN REMOVED FROM THE SURFACE AFTER A SHORT WHILE.
PAINTABLE SECTIONS SUCH AS CEILING, WOODWORKS, ETC. MUST BE PAINTED AND ANY ELECTRIC SWITCHES AND SOCKETS BE DEMOUNTED FROM THE SURFACE BEFORE WALLPAPER APPLICATION.
TO ENSURE PROPER INSULATION AND STICKING, WE RECOMMEND YOU TO APPLY THINNED WALLPAPER GLUE WITH WATER ON THE SURFACE BY USING A ROLL/BRUSH ONE DAY BEFORE THE APPLICATION OF WALLPAPER.
PREPARATION OF GLUE
FILL A CLEAN BUCKET WITH INSTRUCTED AMOUNT OF WATER AT ROOM TEMPERATURE.
POUR GLUE LITTLE BY LITTLE INTO THE BUCKET, AND MIX IT CONTINUOUSLY UNTIL IT BECOMES COAGULATED. IF ANY GLUE LUMPS OR DEPOSITS OCCUR STRAIN THEM BY USING A GAUZE.
IMPORTANT
NO AIR CIRCULATION MUST BE PRESENT IN THE ROOM TO BE WALLPAPERED AND ALL THE DOORS AND WINDOWS MUST BE KEPT CLOSED DURING STICKING AND DRYING PHASES.
APPLICATION OF BORDERS
ENSURE THAT THE SURFACE TO BE BORDERED MUST BE CLEAN AND DRY.
PUT MARKS AT SOME POINTS TO SHOW THE HEIGHT OF BORDER ON THE WALL.
IF YOU USE NON-ADHESIVE BORDER APPLY GLUE AS WITH WALLPAPER APPLICATION.
AFTER YOU HAVE STUCK THE BORDER ONTO THE WALL REMOVE AIR BUBBLES AND
EXCESS GLUE USING A CLEAN CLOTH OR SPONGE.
IF YOU USE SELF-ADHESIVE BORDER APPLY PRESSURE ON THE BORDER USING A CLEAN
CLOTH, SPONGE, OR SMALL ROLL TO ENSURE PROPER STICKING.
|
|
|
|
|
